Traffic Predict

Best Time to Drive from Culver City to Fontana

Right now (3:20 pm PST): about 93 minutes via I-10 East, usually 71 at this time.

Only 42% of this drive is measured by working traffic sensors right now. The rest is estimated from nearby sensors, typical speeds and street traffic, so times can be off. Why so few sensors work.

Type any two places to check another drive. Address search and routing powered by Geoapify.

Typical drive time by departure time

Minutes from Culver City to Fontana by day and time you leave (local time)
Leave5am6am7am8am9am10am11am12pm1pm2pm3pm4pm5pm6pm7pm8pm9pm
Mon55575962606263647088123124129105776355
Tue555760646061636469101130139133115916855
Wed55576065616363657294133137128112927256
Thu565759636162636477101125139127109907558
Fri56576064636467739511213812812498817057
Sat5656575858596062667072727168636256
Sun5656565757585960616260596061616156

About this drive

On weekdays the 60-mile drive from Culver City to Fontana (via I-10 East) usually takes as little as 55 minutes and up to 141 minutes, when leaving around 3:30 pm on Tuesdays. The fastest times to leave are before 7:30 am or after 9 pm. Midday (11 am to 2 pm) it takes about 75 minutes. On weekends it is slowest around 2:30 pm on Saturdays (79 minutes).

About 57 miles of it is freeway, where times follow typical and live traffic from our sensors, and about 4 miles surface streets (5 to 14 minutes on weekdays), estimated from how jammed the freeways around them are at that time. Drive times are measured from central Culver City to central Fontana along the route on the map. Starting or ending elsewhere in a big city can add or save several minutes.

Simulated from typical freeway speeds at each point of the drive for the time you would reach it, from every 5-minute reading we have recorded. We don't have sensors on surface streets yet, so the time on them is estimated from how congested the freeways around each end of the drive are at that time, in both directions: streets jam when the freeways do.

Questions

What is the best time to drive from Culver City to Fontana?

On weekdays, leave before 7:30 am or after 9 pm. The drive usually takes about 55 minutes then, versus up to 141 minutes at the worst times.

How long does it take to drive from Culver City to Fontana?

The 60-mile drive usually takes 55 to 141 minutes on weekdays, depending on when you leave, and about 75 minutes midday.

When is traffic worst from Culver City to Fontana?

Leaving around 3:30 pm on Tuesdays is usually slowest, about 141 minutes.

Freeways on this drive

More drives

Open the live traffic map →