Traffic Predict

Best Time to Drive from Culver City to Ontario

Right now (4:52 pm PDT): about 111 minutes via I-10 East, usually 102 at this time.

Only 27% of this drive is measured by working traffic sensors right now. The rest is estimated from nearby sensors, typical speeds and street traffic, so times can be off. Why so few sensors work.

Type any two places to check another drive. Address search and routing powered by Geoapify.

Typical drive time by departure time

Minutes from Culver City to Ontario by day and time you leave (local time)
Leave5am6am7am8am9am10am11am12pm1pm2pm3pm4pm5pm6pm7pm8pm9pm
Mon4445465048505051547510611211688605044
Tue4445465148495052548110712111798745445
Wed4446485249505052577712012411799775945
Thu4445475249495051598211212311598796447
Fri4446475250515259809411610610279635645
Sat4545464647474850515860595852484945
Sun4444454646464747474847474747474844

About this drive

On weekdays the 48-mile drive from Culver City to Ontario (via I-10 East) usually takes as little as 44 minutes and up to 124 minutes, when leaving around 4 pm on Wednesdays. The fastest times to leave are before 7:30 am or after 9 pm. Midday (11 am to 2 pm) it takes about 60 minutes. On weekends it is slowest around 2:30 pm on Saturdays (66 minutes).

About 45 miles of it is freeway, where times follow typical and live traffic from our sensors, and about 3 miles surface streets (5 to 9 minutes on weekdays), estimated from how jammed the freeways around them are at that time. Drive times are measured from central Culver City (Duquesne Avenue) to central Ontario (Holt Boulevard) along the route on the map. Starting or ending elsewhere in a big city can add or save several minutes.

Simulated from typical freeway speeds at each point of the drive for the time you would reach it, from every 5-minute reading we have recorded. We don't have sensors on surface streets yet, so the time on them is estimated from how congested the freeways around each end of the drive are at that time, in both directions: streets jam when the freeways do.

Questions

What is the best time to drive from Culver City to Ontario?

On weekdays, leave before 7:30 am or after 9 pm. The drive usually takes about 44 minutes then, versus up to 124 minutes at the worst times.

How long does it take to drive from Culver City to Ontario?

The 48-mile drive usually takes 44 to 124 minutes on weekdays, depending on when you leave, and about 60 minutes midday.

When is traffic worst from Culver City to Ontario?

Leaving around 4 pm on Wednesdays is usually slowest, about 124 minutes.

Freeways on this drive

More drives

Open the live traffic map →