Traffic Predict

Best Time to Drive from Culver City to Rialto

Right now (5:06 pm PST): about 125 minutes via I-10 East, usually 131 at this time.

Only 36% of this drive is measured by working traffic sensors right now. The rest is estimated from nearby sensors, typical speeds and street traffic, so times can be off. Why so few sensors work.

Type any two places to check another drive. Address search and routing powered by Geoapify.

Typical drive time by departure time

Minutes from Culver City to Rialto by day and time you leave (local time)
Leave5am6am7am8am9am10am11am12pm1pm2pm3pm4pm5pm6pm7pm8pm9pm
Mon59626567666869707692129129134109826860
Tue606267696567687073101128142136119957360
Wed59636770666767697595134138131117967660
Thu606265686566686978100127138129110938062
Fri606264696869737795109138125124102857562
Sat6161626263636466697375757572676661
Sun6060606061626364656564636465656560

About this drive

On weekdays the 65-mile drive from Culver City to Rialto (via I-10 East) usually takes as little as 59 minutes and up to 142 minutes, when leaving around 4 pm on Tuesdays. The fastest times to leave are before 7 am or after 9 pm. Midday (11 am to 2 pm) it takes about 78 minutes. On weekends it is slowest around 2:30 pm on Saturdays (83 minutes).

About 60 miles of it is freeway, where times follow typical and live traffic from our sensors, and about 5 miles surface streets (6 to 11 minutes on weekdays), estimated from how jammed the freeways around them are at that time. Drive times are measured from central Culver City to central Rialto along the route on the map. Starting or ending elsewhere in a big city can add or save several minutes.

Simulated from typical freeway speeds at each point of the drive for the time you would reach it, from every 5-minute reading we have recorded. We don't have sensors on surface streets yet, so the time on them is estimated from how congested the freeways around each end of the drive are at that time, in both directions: streets jam when the freeways do.

Questions

What is the best time to drive from Culver City to Rialto?

On weekdays, leave before 7 am or after 9 pm. The drive usually takes about 59 minutes then, versus up to 142 minutes at the worst times.

How long does it take to drive from Culver City to Rialto?

The 65-mile drive usually takes 59 to 142 minutes on weekdays, depending on when you leave, and about 78 minutes midday.

When is traffic worst from Culver City to Rialto?

Leaving around 4 pm on Tuesdays is usually slowest, about 142 minutes.

Freeways on this drive

More drives

Open the live traffic map →