Traffic Predict

Best Time to Drive from Culver City to San Bernardino

Right now (3:50 pm PST): about 121 minutes via I-10 East, usually 148 at this time.

Only 27% of this drive is measured by working traffic sensors right now. The rest is estimated from nearby sensors, typical speeds and street traffic, so times can be off. Why so few sensors work.

Type any two places to check another drive. Address search and routing powered by Geoapify.

Typical drive time by departure time

Minutes from Culver City to San Bernardino by day and time you leave (local time)
Leave5am6am7am8am9am10am11am12pm1pm2pm3pm4pm5pm6pm7pm8pm9pm
Mon646669727173737582100145139141115877264
Tue6466707370727375781111441511431251017764
Wed6367707571727274801061511491381241028264
Thu6466687270717374841111411481371181008466
Fri6567697373747783102121151135132108927967
Sat6565666767686970747881808078727165
Sun6464646565676768697069686869706964

About this drive

On weekdays the 71-mile drive from Culver City to San Bernardino (via I-10 East) usually takes as little as 63 minutes and up to 154 minutes, when leaving around 3:30 pm on Wednesdays. The fastest times to leave are before 7:30 am or after 9 pm. Midday (11 am to 2 pm) it takes about 84 minutes. On weekends it is slowest around 2:30 pm on Saturdays (88 minutes).

About 69 miles of it is freeway, where times follow typical and live traffic from our sensors, and about 1.8 miles surface streets (3 to 7 minutes on weekdays), estimated from how jammed the freeways around them are at that time. Drive times are measured from central Culver City (Duquesne Avenue) to central San Bernardino (West 5th Street) along the route on the map. Starting or ending elsewhere in a big city can add or save several minutes.

Simulated from typical freeway speeds at each point of the drive for the time you would reach it, from every 5-minute reading we have recorded. We don't have sensors on surface streets yet, so the time on them is estimated from how congested the freeways around each end of the drive are at that time, in both directions: streets jam when the freeways do.

Questions

What is the best time to drive from Culver City to San Bernardino?

On weekdays, leave before 7:30 am or after 9 pm. The drive usually takes about 63 minutes then, versus up to 154 minutes at the worst times.

How long does it take to drive from Culver City to San Bernardino?

The 71-mile drive usually takes 63 to 154 minutes on weekdays, depending on when you leave, and about 84 minutes midday.

When is traffic worst from Culver City to San Bernardino?

Leaving around 3:30 pm on Wednesdays is usually slowest, about 154 minutes.

Freeways on this drive

Culver City to San Bernardino over Thanksgiving: when to leave →

More drives

Open the live traffic map →