Traffic Predict

Best Time to Drive from Culver City to Whittier

Right now (12:33 pm PDT): about 57 minutes via I-10 East and I-5 South, usually 71 at this time.

Only 5% of this drive is measured by working traffic sensors right now. The rest is estimated from nearby sensors, typical speeds and street traffic, so times can be off. Why so few sensors work.

Type any two places to check another drive. Address search and routing powered by Geoapify.

Typical drive time by departure time

Minutes from Culver City to Whittier by day and time you leave (local time)
Leave5am6am7am8am9am10am11am12pm1pm2pm3pm4pm5pm6pm7pm8pm9pm
Mon333845473439554858709510510289533330
Tue293253553638445050749710610795634130
Wed30325858383341485583959910190694430
Thu2932535536425262728410210710798624133
Fri2930515952465061799310210410691574633
Sat3029303743425557637069665852444634
Sun3030293031434358586860585346494435

About this drive

On weekdays the 25-mile drive from Culver City to Whittier (via I-10 East and I-5 South) usually takes as little as 29 minutes and up to 110 minutes, when leaving around 4:30 pm on Tuesdays. The fastest times to leave are before 6 am or after 9 pm. Midday (11 am to 2 pm) it takes about 61 minutes. On weekends it is slowest around 2 pm on Saturdays (70 minutes).

About 17 miles of it is freeway, where times follow typical and live traffic from our sensors, and about 8 miles surface streets (15 to 56 minutes on weekdays), estimated from how jammed the freeways around them are at that time. Drive times are measured from central Culver City (Duquesne Avenue) to central Whittier (Painter Avenue) along the route on the map. Starting or ending elsewhere in a big city can add or save several minutes.

Simulated from typical freeway speeds at each point of the drive for the time you would reach it, from every 5-minute reading we have recorded. We don't have sensors on surface streets yet, so the time on them is estimated from how congested the freeways around each end of the drive are at that time, in both directions: streets jam when the freeways do.

Questions

What is the best time to drive from Culver City to Whittier?

On weekdays, leave before 6 am or after 9 pm. The drive usually takes about 29 minutes then, versus up to 110 minutes at the worst times.

How long does it take to drive from Culver City to Whittier?

The 25-mile drive usually takes 29 to 110 minutes on weekdays, depending on when you leave, and about 61 minutes midday.

When is traffic worst from Culver City to Whittier?

Leaving around 4:30 pm on Tuesdays is usually slowest, about 110 minutes.

Freeways on this drive

More drives

Open the live traffic map →