Traffic Predict

Best Time to Drive from Riverside to Diamond Bar

Right now (8:16 pm PST): about 30 minutes via SR-60 West, usually 30 at this time.

Only 43% of this drive is measured by working traffic sensors right now. The rest is estimated from nearby sensors, typical speeds and street traffic, so times can be off. Why so few sensors work.

Type any two places to check another drive. Address search and routing powered by Geoapify.

Typical drive time by departure time

Minutes from Riverside to Diamond Bar by day and time you leave (local time)
Leave5am6am7am8am9am10am11am12pm1pm2pm3pm4pm5pm6pm7pm8pm9pm
Mon2942455043383734343437363634313029
Tue2842454942393735333335393735303029
Wed2943444947373534343435363835303029
Thu2940434841373534343436403935313029
Fri2934353836353536363539403836333029
Sat2930303030313332323231313131303029
Sun2929292929303131313030303030303029

About this drive

On weekdays the 27-mile drive from Riverside to Diamond Bar (via SR-60 West) usually takes as little as 28 minutes and up to 52 minutes, when leaving around 8:30 am on Wednesdays. The fastest times to leave are before 5:30 am or after 7 pm. Midday (11 am to 2 pm) it takes about 34 minutes. On weekends it is slowest around 11 am on Saturdays (33 minutes).

About 17 miles of it is freeway, where times follow typical and live traffic from our sensors, and about 10 miles surface streets (14 to 26 minutes on weekdays), estimated from how jammed the freeways around them are at that time. Drive times are measured from central Riverside to central Diamond Bar along the route on the map. Starting or ending elsewhere in a big city can add or save several minutes.

Simulated from typical freeway speeds at each point of the drive for the time you would reach it, from every 5-minute reading we have recorded. We don't have sensors on surface streets yet, so the time on them is estimated from how congested the freeways around each end of the drive are at that time, in both directions: streets jam when the freeways do.

Questions

What is the best time to drive from Riverside to Diamond Bar?

On weekdays, leave before 5:30 am or after 7 pm. The drive usually takes about 28 minutes then, versus up to 52 minutes at the worst times.

How long does it take to drive from Riverside to Diamond Bar?

The 27-mile drive usually takes 28 to 52 minutes on weekdays, depending on when you leave, and about 34 minutes midday.

When is traffic worst from Riverside to Diamond Bar?

Leaving around 8:30 am on Wednesdays is usually slowest, about 52 minutes.

Freeways on this drive

More drives

Open the live traffic map →