Traffic Predict

Best Time to Drive from Sawtelle to Culver City

Right now (5:49 am PST): about 6 minutes via I-10 East, usually 8 at this time.

Type any two places to check another drive. Address search and routing powered by Geoapify.

Typical drive time by departure time

Minutes from Sawtelle to Culver City by day and time you leave (local time)
Leave5am6am7am8am9am10am11am12pm1pm2pm3pm4pm5pm6pm7pm8pm9pm
Mon8811161814131316213040413728179
Tue8812172116141418253341434232209
Wed8812162117151519263544474533219
Thu8910192119151519253443464535239
Fri889131514141824293645504431219
Sat888899121518192324242319148
Sun888889991213131415161298

How these times are worked out: working traffic sensors measure none of this drive right now. The rest comes from each sensor's recorded history, going back as far as 2018, the nearest working sensors and how busy the streets around each end are, put together into our best estimate. Why so few sensors work.

About this drive

On weekdays the 5-mile drive from Sawtelle to Culver City (via I-10 East) usually takes as little as 8 minutes and up to 50 minutes, when leaving around 5 pm on Fridays. The fastest times to leave are before 7 am or after 9 pm. Midday (11 am to 2 pm) it takes about 18 minutes. On weekends it is slowest around 4:30 pm on Saturdays (24 minutes).

About 3 miles of it is freeway, where times follow typical and live traffic from our sensors, and about 1.7 miles surface streets (3 to 9 minutes on weekdays), estimated from how jammed the freeways around them are at that time. Drive times are measured from central Sawtelle to central Culver City along the route on the map. Starting or ending elsewhere in a big city can add or save several minutes.

Simulated from typical freeway speeds at each point of the drive for the time you would reach it, from every 5-minute reading we have recorded. We don't have sensors on surface streets yet, so the time on them is estimated from how congested the freeways around each end of the drive are at that time, in both directions: streets jam when the freeways do.

Questions

What is the best time to drive from Sawtelle to Culver City?

On weekdays, leave before 7 am or after 9 pm. The drive usually takes about 8 minutes then, versus up to 50 minutes at the worst times.

How long does it take to drive from Sawtelle to Culver City?

The 5-mile drive usually takes 8 to 50 minutes on weekdays, depending on when you leave, and about 18 minutes midday.

When is traffic worst from Sawtelle to Culver City?

Leaving around 5 pm on Fridays is usually slowest, about 50 minutes.

Freeways on this drive

More drives

Open the live traffic map →