Traffic Predict

Best Time to Drive from SNA to Culver City

Right now (9:35 pm PST): about 41 minutes via I-405 North, usually 41 at this time.

None of this drive is measured by working traffic sensors right now. The rest is estimated from nearby sensors, typical speeds and street traffic, so times can be off. Why so few sensors work.

Type any two places to check another drive. Address search and routing powered by Geoapify.

Typical drive time by departure time

Minutes from SNA to Culver City by day and time you leave (local time)
Leave5am6am7am8am9am10am11am12pm1pm2pm3pm4pm5pm6pm7pm8pm9pm
Mon4054696462585153524948495251454541
Tue407711410283716153504849505756484642
Wed407312211084726155545351535755525243
Thu40741109576735857515152545855504741
Fri4070957464576659555349505252494641
Sat4142424445485654606057545148494741
Sun4141434243455052676161495149474741

About this drive

On weekdays the 44-mile drive from SNA to Culver City (via I-405 North) usually takes as little as 40 minutes and up to 122 minutes, when leaving around 7 am on Wednesdays. The fastest times to leave are before 5:30 am or after 9 pm. Midday (11 am to 2 pm) it takes about 54 minutes. On weekends it is slowest around 1 pm on Sundays (67 minutes).

About 41 miles of it is freeway, where times follow typical and live traffic from our sensors, and about 3 miles surface streets (4 to 9 minutes on weekdays), estimated from how jammed the freeways around them are at that time. Drive times are measured from John Wayne Airport, Orange County (SNA) (Paularino Avenue) to central Culver City (Duquesne Avenue) along the route on the map. Starting or ending elsewhere in a big city can add or save several minutes.

Simulated from typical freeway speeds at each point of the drive for the time you would reach it, from every 5-minute reading we have recorded. We don't have sensors on surface streets yet, so the time on them is estimated from how congested the freeways around each end of the drive are at that time, in both directions: streets jam when the freeways do.

Questions

What is the best time to drive from SNA to Culver City?

On weekdays, leave before 5:30 am or after 9 pm. The drive usually takes about 40 minutes then, versus up to 122 minutes at the worst times.

How long does it take to drive from SNA to Culver City?

The 44-mile drive usually takes 40 to 122 minutes on weekdays, depending on when you leave, and about 54 minutes midday.

When is traffic worst from SNA to Culver City?

Leaving around 7 am on Wednesdays is usually slowest, about 122 minutes.

Freeways on this drive

SNA to Culver City over Thanksgiving: when to leave →

More drives

Open the live traffic map →