Traffic Predict

Best Time to Drive from Tinton Falls to Brooklyn

Type any two places to check another drive. Address search and routing powered by Geoapify and LocationIQ.

Typical drive time by departure time

Minutes from Tinton Falls to Brooklyn by day and time you leave (local time)
Leave5am6am7am8am9am10am11am12pm1pm2pm3pm4pm5pm6pm7pm8pm9pm
Mon81112111112100868278797880818480757372
Tue80119119117104948380787779818381767473
Wed82119122117106908882828189848882757474
Thu81111114113106929186858081899595847573
Fri7798979486828180858910910110094817674
Sat6969707375787981828482848883797876
Sun6969697071747782858684858584807978

How these times are worked out: working traffic sensors measure none of this drive right now. The rest comes from each sensor's recorded history, the nearest working sensors and how busy the streets around each end are, put together into our best estimate. Why so few sensors work.

About this drive

On weekdays the 50-mile drive from Tinton Falls to Brooklyn (via NY-440 North and I-278 East and I-278 North) usually takes as little as 72 minutes and up to 126 minutes, when leaving around 6:30 am on Wednesdays. The fastest times to leave are after 7 pm. Midday (11 am to 2 pm) it takes about 82 minutes. On weekends it is slowest around 5:30 pm on Saturdays (89 minutes).

About 25 miles of it is freeway, where times follow typical and live traffic from our sensors, and about 25 miles surface streets (26 to 44 minutes on weekdays), estimated from how jammed the freeways around them are at that time. Drive times are measured from central Tinton Falls to central Brooklyn along the route on the map. Starting or ending elsewhere in a big city can add or save several minutes.

Simulated from typical freeway speeds at each point of the drive for the time you would reach it, from every 5-minute reading we have recorded. We don't have sensors on surface streets yet, so the time on them is estimated from how congested the freeways around each end of the drive are at that time, in both directions: streets jam when the freeways do.

Questions

What is the best time to drive from Tinton Falls to Brooklyn?

On weekdays, leave after 7 pm. The drive usually takes about 72 minutes then, versus up to 126 minutes at the worst times.

How long does it take to drive from Tinton Falls to Brooklyn?

The 50-mile drive usually takes 72 to 126 minutes on weekdays, depending on when you leave, and about 82 minutes midday.

When is traffic worst from Tinton Falls to Brooklyn?

Leaving around 6:30 am on Wednesdays is usually slowest, about 126 minutes.

More drives

Open the live traffic map →