Traffic Predict

Best Time to Drive from Corona to Culver City

Right now (10:18 am PDT): about 71 minutes via SR-91 West and I-5 North, usually 63 at this time.

Only 10% of this drive is measured by working traffic sensors right now. The rest is estimated from nearby sensors, typical speeds and street traffic, so times can be off. Why so few sensors work.

Type any two places to check another drive. Address search and routing powered by Geoapify.

Typical drive time by departure time

Minutes from Corona to Culver City by day and time you leave (local time)
Leave5am6am7am8am9am10am11am12pm1pm2pm3pm4pm5pm6pm7pm8pm9pm
Mon5377918574646060606060596056535251
Tue53761009182686259585961616257555251
Wed5377929080686159585863646258545250
Thu5376948673676260596063666558565351
Fri5369726664646263646569676966585451
Sat5153555659616464646162626158575452
Sun5151515255586062626161606060595952

About this drive

On weekdays the 56-mile drive from Corona to Culver City (via SR-91 West and I-5 North) usually takes as little as 50 minutes and up to 100 minutes, when leaving around 7 am on Tuesdays. The fastest times to leave are before 5:30 am or after 7 pm. Midday (11 am to 2 pm) it takes about 60 minutes. On weekends it is slowest around 10:30 am on Saturdays (65 minutes).

About 53 miles of it is freeway, where times follow typical and live traffic from our sensors, and about 3 miles surface streets (4 to 7 minutes on weekdays), estimated from how jammed the freeways around them are at that time. Drive times are measured from central Corona (East 6th Street) to central Culver City (Duquesne Avenue) along the route on the map. Starting or ending elsewhere in a big city can add or save several minutes.

Simulated from typical freeway speeds at each point of the drive for the time you would reach it, from every 5-minute reading we have recorded. We don't have sensors on surface streets yet, so the time on them is estimated from how congested the freeways around each end of the drive are at that time, in both directions: streets jam when the freeways do.

Questions

What is the best time to drive from Corona to Culver City?

On weekdays, leave before 5:30 am or after 7 pm. The drive usually takes about 50 minutes then, versus up to 100 minutes at the worst times.

How long does it take to drive from Corona to Culver City?

The 56-mile drive usually takes 50 to 100 minutes on weekdays, depending on when you leave, and about 60 minutes midday.

When is traffic worst from Corona to Culver City?

Leaving around 7 am on Tuesdays is usually slowest, about 100 minutes.

Freeways on this drive

More drives

Open the live traffic map →