Traffic Predict

Best Time to Drive from Culver City to Corona

Right now (4:52 pm PST): about 104 minutes via SR-91 East and I-5 South, usually 113 at this time.

Only 23% of this drive is measured by working traffic sensors right now. The rest is estimated from nearby sensors, typical speeds and street traffic, so times can be off. Why so few sensors work.

Type any two places to check another drive. Address search and routing powered by Geoapify.

Typical drive time by departure time

Minutes from Culver City to Corona by day and time you leave (local time)
Leave5am6am7am8am9am10am11am12pm1pm2pm3pm4pm5pm6pm7pm8pm9pm
Mon5158676859596666717510211210594675550
Tue49567577626062656981105118113102796050
Wed4956737564596264677789959184746152
Thu49577374626268707786109113113102755953
Fri49536669656365728410511611511397736253
Sat5052535561606667707578757268626054
Sun5051505253606167687068666763646254

About this drive

On weekdays the 56-mile drive from Culver City to Corona (via SR-91 East and I-5 South) usually takes as little as 49 minutes and up to 119 minutes, when leaving around 4:30 pm on Tuesdays. The fastest times to leave are before 6 am or after 9 pm. Midday (11 am to 2 pm) it takes about 72 minutes. On weekends it is slowest around 2:30 pm on Saturdays (78 minutes).

About 54 miles of it is freeway, where times follow typical and live traffic from our sensors, and about 2 miles surface streets (3 to 7 minutes on weekdays), estimated from how jammed the freeways around them are at that time. Drive times are measured from central Culver City (Duquesne Avenue) to central Corona (East 6th Street) along the route on the map. Starting or ending elsewhere in a big city can add or save several minutes.

Simulated from typical freeway speeds at each point of the drive for the time you would reach it, from every 5-minute reading we have recorded. We don't have sensors on surface streets yet, so the time on them is estimated from how congested the freeways around each end of the drive are at that time, in both directions: streets jam when the freeways do.

Questions

What is the best time to drive from Culver City to Corona?

On weekdays, leave before 6 am or after 9 pm. The drive usually takes about 49 minutes then, versus up to 119 minutes at the worst times.

How long does it take to drive from Culver City to Corona?

The 56-mile drive usually takes 49 to 119 minutes on weekdays, depending on when you leave, and about 72 minutes midday.

When is traffic worst from Culver City to Corona?

Leaving around 4:30 pm on Tuesdays is usually slowest, about 119 minutes.

Freeways on this drive

Culver City to Corona over Thanksgiving: when to leave →

More drives

Open the live traffic map →