Traffic Predict

Best Time to Drive from Culver City to Downey

Right now (12:33 pm PDT): about 40 minutes via I-10 East and I-5 South, usually 45 at this time.

Only 5% of this drive is measured by working traffic sensors right now. The rest is estimated from nearby sensors, typical speeds and street traffic, so times can be off. Why so few sensors work.

Type any two places to check another drive. Address search and routing powered by Geoapify.

Typical drive time by departure time

Minutes from Culver City to Downey by day and time you leave (local time)
Leave5am6am7am8am9am10am11am12pm1pm2pm3pm4pm5pm6pm7pm8pm9pm
Mon2326303225273733384465757263372421
Tue2122353725263034344768777769452921
Wed2122383827242933375363686963473022
Thu2122353626293540475572777870442824
Fri2121343935323440516473757764403124
Sat2121222629293738414647453935303124
Sun2121212122302938394441393631343025

About this drive

On weekdays the 21-mile drive from Culver City to Downey (via I-10 East and I-5 South) usually takes as little as 21 minutes and up to 80 minutes, when leaving around 4:30 pm on Tuesdays. The fastest times to leave are before 6 am or after 9 pm. Midday (11 am to 2 pm) it takes about 40 minutes. On weekends it is slowest around 3:30 pm on Saturdays (47 minutes).

About 18 miles of it is freeway, where times follow typical and live traffic from our sensors, and about 3 miles surface streets (5 to 20 minutes on weekdays), estimated from how jammed the freeways around them are at that time. Drive times are measured from central Culver City (Duquesne Avenue) to central Downey (Downey Avenue) along the route on the map. Starting or ending elsewhere in a big city can add or save several minutes.

Simulated from typical freeway speeds at each point of the drive for the time you would reach it, from every 5-minute reading we have recorded. We don't have sensors on surface streets yet, so the time on them is estimated from how congested the freeways around each end of the drive are at that time, in both directions: streets jam when the freeways do.

Questions

What is the best time to drive from Culver City to Downey?

On weekdays, leave before 6 am or after 9 pm. The drive usually takes about 21 minutes then, versus up to 80 minutes at the worst times.

How long does it take to drive from Culver City to Downey?

The 21-mile drive usually takes 21 to 80 minutes on weekdays, depending on when you leave, and about 40 minutes midday.

When is traffic worst from Culver City to Downey?

Leaving around 4:30 pm on Tuesdays is usually slowest, about 80 minutes.

Freeways on this drive

More drives

Open the live traffic map →