Traffic Predict

Best Time to Drive from Downey to Culver City

Right now (12:33 pm PDT): about 34 minutes via I-10 West and I-710 North, usually 37 at this time.

Only 3% of this drive is measured by working traffic sensors right now. The rest is estimated from nearby sensors, typical speeds and street traffic, so times can be off. Why so few sensors work.

Type any two places to check another drive. Address search and routing powered by Geoapify.

Typical drive time by departure time

Minutes from Downey to Culver City by day and time you leave (local time)
Leave5am6am7am8am9am10am11am12pm1pm2pm3pm4pm5pm6pm7pm8pm9pm
Mon2341586548373332313029272826242322
Tue2344607156463431292928262525252422
Wed2343657056423431282728262424242322
Thu2340596954423933312930282727272524
Fri2338444939353535383534312930312724
Sat2223272729394239373329313129302725
Sun2222222324282833343333333335353428

About this drive

On weekdays the 21-mile drive from Downey to Culver City (via I-10 West and I-710 North) usually takes as little as 22 minutes and up to 71 minutes, when leaving around 8 am on Tuesdays. The fastest times to leave are before 5:30 am or after 8 pm. Midday (11 am to 2 pm) it takes about 32 minutes. On weekends it is slowest around 11:30 am on Saturdays (42 minutes).

About 17 miles of it is freeway, where times follow typical and live traffic from our sensors, and about 5 miles surface streets (8 to 29 minutes on weekdays), estimated from how jammed the freeways around them are at that time. Drive times are measured from central Downey (Downey Avenue) to central Culver City (Duquesne Avenue) along the route on the map. Starting or ending elsewhere in a big city can add or save several minutes.

Simulated from typical freeway speeds at each point of the drive for the time you would reach it, from every 5-minute reading we have recorded. We don't have sensors on surface streets yet, so the time on them is estimated from how congested the freeways around each end of the drive are at that time, in both directions: streets jam when the freeways do.

Questions

What is the best time to drive from Downey to Culver City?

On weekdays, leave before 5:30 am or after 8 pm. The drive usually takes about 22 minutes then, versus up to 71 minutes at the worst times.

How long does it take to drive from Downey to Culver City?

The 21-mile drive usually takes 22 to 71 minutes on weekdays, depending on when you leave, and about 32 minutes midday.

When is traffic worst from Downey to Culver City?

Leaving around 8 am on Tuesdays is usually slowest, about 71 minutes.

Freeways on this drive

More drives

Open the live traffic map →