Best Time to Drive from Culver City to Palm Springs
Right now (3:50 pm PST): about 142 minutes via I-10 East, usually 147 at this time.
Typical drive time by departure time
| Leave | 5am | 6am | 7am | 8am | 9am | 10am | 11am | 12pm | 1pm | 2pm | 3pm | 4pm | 5pm | 6pm | 7pm | 8pm | 9pm |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Mon | 112 | 114 | 120 | 132 | 130 | 127 | 126 | 132 | 141 | 171 | 211 | 207 | 198 | 172 | 147 | 128 | 114 |
| Tue | 112 | 114 | 124 | 134 | 132 | 128 | 127 | 132 | 142 | 195 | 230 | 225 | 208 | 184 | 158 | 133 | 116 |
| Wed | 112 | 115 | 123 | 137 | 133 | 131 | 129 | 134 | 149 | 183 | 220 | 221 | 200 | 178 | 154 | 138 | 117 |
| Thu | 113 | 115 | 124 | 135 | 134 | 129 | 131 | 136 | 156 | 189 | 216 | 215 | 196 | 176 | 153 | 137 | 118 |
| Fri | 113 | 115 | 120 | 130 | 130 | 131 | 136 | 153 | 181 | 219 | 227 | 218 | 201 | 172 | 155 | 138 | 118 |
| Sat | 113 | 114 | 115 | 116 | 116 | 119 | 125 | 132 | 141 | 148 | 146 | 147 | 145 | 140 | 132 | 125 | 114 |
| Sun | 113 | 112 | 113 | 113 | 114 | 115 | 117 | 120 | 122 | 124 | 122 | 122 | 123 | 125 | 122 | 119 | 113 |
How these times are worked out: working traffic sensors measure 29% of this drive right now. The rest comes from each sensor's recorded history, the nearest working sensors and how busy the streets around each end are, put together into our best estimate. Why so few sensors work.
How was your drive?
Drove this today or yesterday? Tell us how it compared with our typical time. Reports help us find trips where our numbers are off.
About this drive
On weekdays the 117-mile drive from Culver City to Palm Springs (via I-10 East) usually takes as little as 112 minutes and up to 230 minutes, when leaving around 2:30 pm on Fridays. The fastest times to leave are before 7:30 am or after 9 pm. Midday (11 am to 2 pm) it takes about 151 minutes. On weekends it is slowest around 2:30 pm on Saturdays (148 minutes).
About 98 miles of it is freeway, where times follow typical and live traffic from our sensors, and about 19 miles surface streets (17 to 21 minutes on weekdays), estimated from how jammed the freeways around them are at that time. Drive times are measured from central Culver City to central Palm Springs along the route on the map. Starting or ending elsewhere in a big city can add or save several minutes.
Simulated from typical freeway speeds at each point of the drive for the time you would reach it, from every 5-minute reading we have recorded. We don't have sensors on surface streets yet, so the time on them is estimated from how congested the freeways around each end of the drive are at that time, in both directions: streets jam when the freeways do.
Questions
What is the best time to drive from Culver City to Palm Springs?
On weekdays, leave before 7:30 am or after 9 pm. The drive usually takes about 112 minutes then, versus up to 230 minutes at the worst times.
How long does it take to drive from Culver City to Palm Springs?
The 117-mile drive usually takes 112 to 230 minutes on weekdays, depending on when you leave, and about 151 minutes midday.
When is traffic worst from Culver City to Palm Springs?
Leaving around 2:30 pm on Fridays is usually slowest, about 230 minutes.
Freeways on this drive
I-10 East in Inland Empire (57 miles) · I-10 East in Los Angeles (41 miles)
Los Angeles traffic right now · Los Angeles traffic tomorrow
More drives
Culver City to Downtown LA · Culver City to Santa Monica · Culver City to Pasadena · Culver City to Long Beach · Culver City to West Covina · Culver City to Burbank · Culver City to Glendale · Culver City to Santa Clarita · Culver City to Van Nuys · Culver City to Torrance · Culver City to El Monte · Culver City to Downey