Traffic Predict

Best Time to Drive from Culver City to Rancho Cucamonga

Right now (3:20 pm PST): about 83 minutes via I-10 East, usually 63 at this time.

Only 27% of this drive is measured by working traffic sensors right now. The rest is estimated from nearby sensors, typical speeds and street traffic, so times can be off. Why so few sensors work.

Type any two places to check another drive. Address search and routing powered by Geoapify.

Typical drive time by departure time

Minutes from Culver City to Rancho Cucamonga by day and time you leave (local time)
Leave5am6am7am8am9am10am11am12pm1pm2pm3pm4pm5pm6pm7pm8pm9pm
Mon4951525654565656607811211612195675549
Tue49505257545555575986114129124106826150
Wed49515357545655576279121127121103836650
Thu49515257545556566486114128118101826951
Fri4951535755565863819612211211189736251
Sat5050515151525354576264636360545450
Sun4949495050515152535453525253535349

About this drive

On weekdays the 51-mile drive from Culver City to Rancho Cucamonga (via I-10 East) usually takes as little as 49 minutes and up to 129 minutes, when leaving around 4 pm on Tuesdays. The fastest times to leave are before 7:30 am or after 9 pm. Midday (11 am to 2 pm) it takes about 64 minutes. On weekends it is slowest around 2:30 pm on Saturdays (71 minutes).

About 45 miles of it is freeway, where times follow typical and live traffic from our sensors, and about 6 miles surface streets (9 to 14 minutes on weekdays), estimated from how jammed the freeways around them are at that time. Drive times are measured from central Culver City (Duquesne Avenue) to central Rancho Cucamonga along the route on the map. Starting or ending elsewhere in a big city can add or save several minutes.

Simulated from typical freeway speeds at each point of the drive for the time you would reach it, from every 5-minute reading we have recorded. We don't have sensors on surface streets yet, so the time on them is estimated from how congested the freeways around each end of the drive are at that time, in both directions: streets jam when the freeways do.

Questions

What is the best time to drive from Culver City to Rancho Cucamonga?

On weekdays, leave before 7:30 am or after 9 pm. The drive usually takes about 49 minutes then, versus up to 129 minutes at the worst times.

How long does it take to drive from Culver City to Rancho Cucamonga?

The 51-mile drive usually takes 49 to 129 minutes on weekdays, depending on when you leave, and about 64 minutes midday.

When is traffic worst from Culver City to Rancho Cucamonga?

Leaving around 4 pm on Tuesdays is usually slowest, about 129 minutes.

Freeways on this drive

Culver City to Rancho Cucamonga over Thanksgiving: when to leave →

More drives

Open the live traffic map →