Traffic Predict

Best Time to Drive from Rancho Cucamonga to Culver City

Right now (3:03 am PDT): about 50 minutes via I-10 West.

Only 26% of this drive is measured by working traffic sensors right now. The rest is estimated from nearby sensors, typical speeds and street traffic, so times can be off. Why so few sensors work.

Type any two places to check another drive. Address search and routing powered by Geoapify.

Typical drive time by departure time

Minutes from Rancho Cucamonga to Culver City by day and time you leave (local time)
Leave5am6am7am8am9am10am11am12pm1pm2pm3pm4pm5pm6pm7pm8pm9pm
Mon4872837468615857555453525251505050
Tue4976898268625856555453535353525250
Wed5074898472656458565453535564686450
Thu4971847867636057555554545855545650
Fri4959646361595757575556535660736650
Sat4951525255565856595756555555535149
Sun4949495053535454555453545355596151

About this drive

On weekdays the 50-mile drive from Rancho Cucamonga to Culver City (via I-10 West) usually takes as little as 48 minutes and up to 90 minutes, when leaving around 6:30 am on Tuesdays. The fastest times to leave are before 5:30 am or after 8:30 pm. Midday (11 am to 2 pm) it takes about 57 minutes. On weekends it is slowest around 7:30 pm on Sundays (62 minutes).

About 44 miles of it is freeway, where times follow typical and live traffic from our sensors, and about 6 miles surface streets (10 to 14 minutes on weekdays), estimated from how jammed the freeways around them are at that time. Drive times are measured from central Rancho Cucamonga to central Culver City (Duquesne Avenue) along the route on the map. Starting or ending elsewhere in a big city can add or save several minutes.

Simulated from typical freeway speeds at each point of the drive for the time you would reach it, from every 5-minute reading we have recorded. We don't have sensors on surface streets yet, so the time on them is estimated from how congested the freeways around each end of the drive are at that time, in both directions: streets jam when the freeways do.

Questions

What is the best time to drive from Rancho Cucamonga to Culver City?

On weekdays, leave before 5:30 am or after 8:30 pm. The drive usually takes about 48 minutes then, versus up to 90 minutes at the worst times.

How long does it take to drive from Rancho Cucamonga to Culver City?

The 50-mile drive usually takes 48 to 90 minutes on weekdays, depending on when you leave, and about 57 minutes midday.

When is traffic worst from Rancho Cucamonga to Culver City?

Leaving around 6:30 am on Tuesdays is usually slowest, about 90 minutes.

Freeways on this drive

More drives

Open the live traffic map →