Traffic Predict

Best Time to Drive from Culver City to Rowland Heights

Right now (3:50 pm PST): about 51 minutes via SR-60 East and I-10 East, usually 65 at this time.

Type any two places to check another drive. Address search and routing powered by Geoapify and LocationIQ.

Typical drive time by departure time

Minutes from Culver City to Rowland Heights by day and time you leave (local time)
Leave5am6am7am8am9am10am11am12pm1pm2pm3pm4pm5pm6pm7pm8pm9pm
Mon3335405050454447546678848574594535
Tue3335415352464447577386959679654937
Wed3335415352474549587488969681645138
Thu3335415453474550617687949379645239
Fri3334394747475061789195949178645539
Sat3334343536384351596263656356494335
Sun3333333333343538404343424242403834

How these times are worked out: working traffic sensors measure none of this drive right now. The rest comes from each sensor's recorded history, going back as far as 2018, the nearest working sensors and how busy the streets around each end are, put together into our best estimate. Why so few sensors work.

About this drive

On weekdays the 32-mile drive from Culver City to Rowland Heights (via SR-60 East and I-10 East) usually takes as little as 33 minutes and up to 98 minutes, when leaving around 4:30 pm on Wednesdays. The fastest times to leave are before 6:30 am. Midday (11 am to 2 pm) it takes about 58 minutes. On weekends it is slowest around 4 pm on Saturdays (65 minutes).

About 28 miles of it is freeway, where times follow typical and live traffic from our sensors, and about 3 miles surface streets (5 to 12 minutes on weekdays), estimated from how jammed the freeways around them are at that time. Drive times are measured from central Culver City to central Rowland Heights along the route on the map. Starting or ending elsewhere in a big city can add or save several minutes.

Simulated from typical freeway speeds at each point of the drive for the time you would reach it, from every 5-minute reading we have recorded. We don't have sensors on surface streets yet, so the time on them is estimated from how congested the freeways around each end of the drive are at that time, in both directions: streets jam when the freeways do.

Questions

What is the best time to drive from Culver City to Rowland Heights?

On weekdays, leave before 6:30 am. The drive usually takes about 33 minutes then, versus up to 98 minutes at the worst times.

How long does it take to drive from Culver City to Rowland Heights?

The 32-mile drive usually takes 33 to 98 minutes on weekdays, depending on when you leave, and about 58 minutes midday.

When is traffic worst from Culver City to Rowland Heights?

Leaving around 4:30 pm on Wednesdays is usually slowest, about 98 minutes.

Freeways on this drive

More drives

Open the live traffic map →