Traffic Predict

Best Time to Drive from Culver City to Sylmar

Right now (3:50 pm PST): about 37 minutes via I-405 North, usually 48 at this time.

Type any two places to check another drive. Address search and routing powered by Geoapify and LocationIQ.

Typical drive time by departure time

Minutes from Culver City to Sylmar by day and time you leave (local time)
Leave5am6am7am8am9am10am11am12pm1pm2pm3pm4pm5pm6pm7pm8pm9pm
Mon3132364040383738446510612411383503532
Tue3132374141393738466911413311789603832
Wed3132374141393637456811113211893644033
Thu3232384243403739506710412911488613933
Fri3132353939383639517710712210679523832
Sat3131323233343636373943484340363432
Sun3131313131323435363637373737353432

How these times are worked out: working traffic sensors measure 3% of this drive right now. The rest comes from each sensor's recorded history, going back as far as 2018, the nearest working sensors and how busy the streets around each end are, put together into our best estimate. Why so few sensors work.

About this drive

On weekdays the 28-mile drive from Culver City to Sylmar (via I-405 North) usually takes as little as 31 minutes and up to 133 minutes, when leaving around 4 pm on Tuesdays. The fastest times to leave are before 7 am or after 9 pm. Midday (11 am to 2 pm) it takes about 46 minutes. On weekends it is slowest around 4 pm on Saturdays (48 minutes).

About 26 miles of it is freeway, where times follow typical and live traffic from our sensors, and about 1.9 miles surface streets (2 to 9 minutes on weekdays), estimated from how jammed the freeways around them are at that time. Drive times are measured from central Culver City to central Sylmar along the route on the map. Starting or ending elsewhere in a big city can add or save several minutes.

Simulated from typical freeway speeds at each point of the drive for the time you would reach it, from every 5-minute reading we have recorded. We don't have sensors on surface streets yet, so the time on them is estimated from how congested the freeways around each end of the drive are at that time, in both directions: streets jam when the freeways do.

Questions

What is the best time to drive from Culver City to Sylmar?

On weekdays, leave before 7 am or after 9 pm. The drive usually takes about 31 minutes then, versus up to 133 minutes at the worst times.

How long does it take to drive from Culver City to Sylmar?

The 28-mile drive usually takes 31 to 133 minutes on weekdays, depending on when you leave, and about 46 minutes midday.

When is traffic worst from Culver City to Sylmar?

Leaving around 4 pm on Tuesdays is usually slowest, about 133 minutes.

Freeways on this drive

More drives

Open the live traffic map →